Flatline City

This project is a collection of modular pieces for holding your Flatline city terrain when not in use. In the case of Flatline, "collection" may be a bit of a stretch as the only supported piece as of now is the freebie container demo piece.

Note that the project is not affiliated with Saucermen Studios, makes no claim to their intellectual properly and does not include any of their models. If you're interested in those models, see Flatline City over on their site.

Printing recommendations

Layer height: 0.2mm (important!)
Perimeter/Wall/Wall loops: 2
Infill: 10%
Top layers: 7
Bottom layers: 2
Nozzle: 0.4mm (other sizes may work but are untested)
Supports: Not necessary
Brim: Slicer defaults

Most pieces will print without a brim. Pieces that are particularly tall and thin (100 mm or taller) or have a very small contact surface with the plate may require one. Prusa Slicer and derivates such as Bambu Slicer or Orca Slicer seem to provide good auto settings for this. All pieces are pre-oriented for printing in the optimal direction.

Please allow the pieces time to cool to room temperature before assembly; some of the tolerances are tight enough that heat expansion is a factor. Glue is not required.